First. the use and maintenance
The use of laboratory reactor must be closed refrigerant inlet pipe valve, and put pot and clip refrigerant remaining in the sleeve, and then enter the material, start the blender, then open the steam valve and the electric power supply, to reach the required temperature, should first close the steam valve and the electric power supply, 2~3 minutes later, and then close the blender. After processing, the jacket and put the remaining condensed water, should rinse with warm water, brush off a sticky material, and then use the 40~500C base on the inner wall of the container clean, rinse with water, especially the no material (heat absorption medium) empty pot case, shall open the steam valve and the electric power supply. Pay special attention to the use of steam pressure shall not exceed the rated working pressure. Maintenance of laboratory reactor should always pay attention to the whole equipment and reducer work, lack of lubricants for deceleration should be added immediately, the electric heating medium oil every six months to be replaced on the jacket and cover and other parts of the safety valve, pressure gauge, thermometer, distillation hole, electric heating rods, electrical instrument should be regularly check, if there is failure to immediately replace or repair equipment when not in use, be sure to use warm water in the inner wall and the outer wall of the container comprehensive cleaning, regular cleaning of the pot body, keep clean and bright and durable liner, achieve the objective.
Second. matters needing attention
1. laboratory reactor is working at normal temperature, must be normal cooling water, so as to avoid magnetic steel magnetic reduction and demagnetization.
2. heating setting and heating up speed (100 /h), not too large lifting speed.